Search results
Results from the WOW.Com Content Network
On larger CRT monitors (17 in or 43 cm or larger), most people experience mild discomfort unless the refresh is set to 72 Hz or higher. A rate of 100 Hz is comfortable at almost any size. However, this does not apply to LCD monitors. The closest equivalent to a refresh rate on an LCD monitor is its frame rate, which is often locked at 60 fps ...
A refresh rate of 60 Hz on most screens will produce a visible "flickering" effect. Most people find that refresh rates of 70–90 Hz and above enable flicker-free viewing on CRTs. Use of refresh rates above 120 Hz is uncommon, as they provide little noticeable flicker reduction and limit available resolution.
Flicker-free is a term given to video displays, primarily cathode-ray tubes, operating at a high refresh rate to reduce or eliminate the perception of screen flicker.For televisions, this involves operating at a 100 Hz or 120 Hz hertz field rate to eliminate flicker, compared to standard televisions that operate at 50 Hz (PAL, SÉCAM systems) or 60 Hz (), most simply done by displaying each ...
refresh rate of PAL and SECAM CRT televisions: 60 Hz: Electromagnetic – standard AC mains power (American AC, Osaka AC), refresh rate of NTSC CRT televisions and standard refresh rate of computer monitors: 10 2: 100 Hz 100 Hz: Cyclic rate of a typical automobile engine at redline (equivalent to 6000 rpm) 261.626 Hz
The refresh rate of the video signal can be higher than 41 Hz (or 48 Hz) but the monitor will not update the display any faster even if graphics card(s) do so. [citation needed] In June 2001, WQUXGA was introduced in the IBM T220 LCD monitor using a LCD panel built by IDTech.
Some systems could increase refresh rate to higher values such as 72, 75, 100, or 120 Hz to ease this problem, though even if the faster refresh is an integer multiple of the source material framerate to eliminate judder, without higher framerate source material this causes the perception of duplicate images. [7]
Does not normally occur due to a high refresh rate higher than FPS [25] Does not normally occur at 100% brightness level. At levels below 100% flicker often occurs with frequencies between 60 and 255 Hz, since often pulse-width modulation is used to dim OLED screens. [26] [27] Risk of image persistence or burn-in: High [28] Low [28] High [28 ...
The second revision ("XGA-2") was a more thorough upgrade, offering higher refresh rates (75 Hz and up, non-interlaced, up to at least 1024×768), improved performance, and a fully programmable display engine capable of almost any resolution within its physical limits.