Search results
Results from the WOW.Com Content Network
It is possible to select the input source using a VCP command. Some monitors will only take VCP commands from the active input source, others will take commands from any connected input source. Three categories of controls exist: Continuous (C) Allow values between zero and a maximum value. Non-continuous (NC) Only support a limited set of values.
A flat-panel display (FPD) computer monitor A cathode-ray tube (CRT) computer monitor A computer monitor is an output device that displays information in pictorial or textual form. A discrete monitor comprises a visual display , support electronics, power supply, housing , electrical connectors , and external user controls.
The modern DE-15 connector can carry Display Data Channel to allow the monitor to communicate with the graphics card, and optionally vice versa. [1] Being replaced by DVI from 1999 onward. DB13W3: Analog computer video, color and monochrome. Sun Microsystems, Silicon Graphics, IBM RISC, Intergraph and some Apple Computer computer workstations.
Some computers came with a built-in RF modulator to allow connection to the TV receiver antenna terminals; others output composite video for use with a free-standing monitor or external RF modulator. Still others had built-in or proprietary monitors. Often a composite video monitor (monochrome or color) would be substituted for the family TV.
The New York Times said that MSBACKUP "is much better and faster than the old BACKUP command used in earlier versions of DOS, but it does lack some of the advanced features found in backup software packages that are sold separately. [18] There is another offering, named MWBACKUP, that is GUI-oriented. It was introduced for Windows for ...
This is the highest resolution that generally can be displayed on analog computer monitors (most CRTs), and the highest resolution that most analogue video cards and other display transmission hardware (cables, switch boxes, signal boosters) are rated for (at 60 Hz refresh). 24-bit colour requires 9 MB of video memory (and transmission ...
Installation (or setup) of a computer program (including device drivers and plugins), is the act of making the program ready for execution. Installation refers to the particular configuration of software or hardware with a view to making it usable with the computer. A soft or digital copy of the piece of software (program) is needed to install it.
The difference between these two modes can only be seen on a composite monitor, where mode 0 disables the color burst, making all text appear in grayscale. Mode 1 enables the color burst, allowing for color. Mode 0 and Mode 1 are functionally identical on RGB monitors and on later adapters that emulate CGA without supporting composite color output.