Search results
Results from the WOW.Com Content Network
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
AMP Mate-n-Lok and Molex 8981 0.093-inch pin and socket power connectors Molex standard 0.093-inch pin and socket connectors Molex disk drive power connection system tool and connectors Molex Mini-Fit Jr. connector as used for ATX power supply. A Molex connector is a two-piece pin-and-socket interconnection which became an early electronic ...
ATX motherboard power connector (usually called P1): This is the connector that goes to the motherboard to provide it with power. The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire (it is usually green). This connector is the largest of all the connectors. In older AT power supplies, this connector was split in two: P8 ...
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
English: 24-pin ATX power plug, from a Seasonic ATX PSU; pins 11, 12, 23 and 24 form a detachable separate four-pin plug, making it backward compatible with 20-pin ATX receptacles. Date 5 November 2013, 00:46
The 16-pin 12VHPWR connector is a standard for connecting graphics processing units (GPUs) to computer power supplies for up to 600 W power delivery. It was introduced by Nvidia in 2022 to supersede the previous 6- and 8-pin power connectors for GPUs. The stated aim was to cater to the increasing power requirements of Nvidia GPUs.
Mini-ITX 2.0 SoC mainboard with ATX12V connector installed in a Micro-ATX computer case. The Mini-ITX standard does not define a standard for the computer power supply, though it suggests possible options. Conventionally Mini-ITX boards use a 20- or 24-pin "original ATX" power connector.
Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...