Search results
Results from the WOW.Com Content Network
The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...
Hall effect current sensor with internal integrated circuit amplifier. 8 mm opening. Zero current output voltage is midway between the supply voltages that maintain a 4 to 8-volt differential. The non-zero current response is proportional to the voltage supplied and is linear to 60 amperes for this particular (25 A) device.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
Active signal is issued when both lines present 0 V; a single line presenting 0 V for a duration longer than the test pulses is sufficient to signal an event. Some related terms: Electrosensitive protective equipment (ESPE) - a device such as a light curtain, safety scanner, or gate position sensor. The ESPE has OSSD outputs.
The "1.2/50 μs" generator is designed for insulation testing, and produces a high-voltage, low-current impulse into a high-impedance load. The output current of this generator is on the milliampere scale. [2] [5] The "8/20 μs" generator is designed for surge arrester testing, and produces a high-current surge into a low-impedance load. [2]
Commonly-used circuit symbol Operation of the reed switch The reed switch [ i ] is an electromechanical switch operated by an applied magnetic field . It was invented in 1922 by professor Valentin Kovalenkov at the Petrograd Electrotechnical University , [ 1 ] and later evolved at Bell Telephone Laboratories in 1936 by Walter B. Ellwood into ...
The conventional "hole" current is in the negative direction of the electron current and the negative of the electrical charge which gives I x = ntw(−v x)(−e) where n is charge carrier density, tw is the cross-sectional area, and −e is the charge of each electron.