Search results
Results from the WOW.Com Content Network
A chart datum is the water level surface serving as origin of depths displayed on a nautical chart and for reporting and predicting tide heights. A chart datum is generally derived from some tidal phase, in which case it is also known as a tidal datum. [1] Common chart datums are lowest astronomical tide (LAT) [1] and mean lower low water (MLLW).
Chert (/ tʃ ɜːr t /) is a hard, fine-grained sedimentary rock composed of microcrystalline or cryptocrystalline quartz, [1] the mineral form of silicon dioxide (SiO 2). [2] Chert is characteristically of biological origin, but may also occur inorganically as a chemical precipitate or a diagenetic replacement, as in petrified wood. [3]
Water level, also known as gauge height or stage, is the elevation of the free surface of a sea, stream, lake or reservoir relative to a specified vertical datum. [1]
Standard sea-level conditions (SSL), [1] also known as sea-level standard (SLS), defines a set of atmospheric conditions for physical calculations. The term "standard sea level " is used to indicate that values of properties are to be taken to be the same as those standard at sea level, and is done to define values for use in general calculations.
The compaction of radiolarites is dependent on their chemical composition and correlates positively with the original SiO 2-content. The compaction factor varies generally between 3.2 and 5, which means that 1 meter of consolidated sediment is equivalent to 3.2 to 5 meters of ooze.
When using the chart, it is important to remember these tips: Isotropic and opaque (metallic) minerals cannot be identified this way. The stage of the microscope should be rotated until maximum colour is found, and therefore, the maximum birefringence. Each mineral, depending on the orientation, may not exhibit the maximum birefringence.
On nautical charts, the top of the chart is always true north, rather than magnetic north, towards which a compass points. Most charts include a compass rose depicting the variation between magnetic and true north. However, the use of the Mercator projection has drawbacks. This projection shows the lines of longitude as parallel.
The reference water levels are used on inland waterways to define a range of water levels allowing the full use of the waterway for navigation. [1] Ship passage can be limited by the water levels that are too low, when the fairway might become too shallow for large ("target", "design") ships, or too high, when it might become impossible for the target ships to pass under the bridges. [1]