Search results
Results from the WOW.Com Content Network
The connector first appeared in the Nvidia RTX 40 GPUs. [5] [6] The prior Nvidia RTX 30 series introduced a similar, proprietary connector in the "Founder's Edition" cards, which also uses an arrangement of twelve pins for power, but did not have the sense pins, except for the connector on the founders edition RTX 3090 Ti (though not present on the adapter supplied with those cards.) [7]
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin, i.e. 20+4-pin form) which can be used together to form the 24-pin connector.
The Cisco Supervisor Engine serves as the management card for modular Cisco switches that can also, in some cases, act as forwarding/routing element. [1]Over time, the Supervisor Engine has undergone multiple iterations and was different for different modular switches in Cisco Portfolio (Catalyst 4000, 4500, 5000, 5500, 6000, 6500, 9400, 9600 and Nexus switches).
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.
12VHPWR adapter (12VHPWR output on the left, four 8-pin inputs on the right) supplied with Nvidia RTX 4090 cards 16-pin 12VHPWR connector. The 16-pin 12VHPWR connector is a standard for connecting graphics processing units (GPUs) to computer power supplies for up to 600 W power delivery. It was introduced in 2022 to supersede the previous 6 ...
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
SCSI hard drives showing 80-pin SCA connector (top), and separate 68-pin and power connectors plus configuration jumpers (bottom) SCSI backplane with 80-pin SCA connectors. Hard Drives are mounted on proprietary hot-swappable caddies. Single Connector Attachment, or SCA, is a type of connection for the internal cabling of Parallel SCSI systems ...