Search results
Results from the WOW.Com Content Network
The first sectional chart was published in 1930; in 1937 the full series of the lower 48 states was completed. These early sectional charts were smaller (most covered two degrees of latitude and six of longitude) with the map on one side; after 1950 the legend and index to adjoining charts was on the reverse.
A sectional chart is a two-sided chart created from a Lambert Conformal Conic Projection [1] with two defined standard parallels. The scale is 1:500,000, with a contour interval of 500 feet. The size of each sectional is designed to be "arm's width" when completely unfolded.
FAA-Terminal Area Chart Baltimore-Washington from 2011. Like the VFR sectional charts that they complement, terminal area charts depict topographic features and other information of interest to aviators flying visually, including major landmarks, terrain elevations, visual navigation routes, ground-based navigation aids, airports, rivers, cities, and airspace boundaries.
A World Aeronautical Chart (WAC) was a type of aeronautical chart used for navigation by pilots of moderate speed aircraft and aircraft at high altitudes in the United States. They are at a scale of 1:1,000,000 (about 1 inch = 13.7 nautical miles or 16 statute miles).
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
Military Training Routes are divided into Instrument Routes (IR), and Visual Routes (VR). Each route is identified by either of these two letters, followed by either four digits for routes below 1,500 feet above ground level, or three digits for routes extending for at least one leg above 1,500ft AGL.
The airspace is charted on a VFR sectional chart with a series of blue lines. Within these blue lines, the floor and the ceiling of the Class B airspace is defined. The lateral boundaries of Class B airspace are individually tailored to facilitate arriving and departing traffic operating under IFR.
En-route charts are divided into high and low versions, with information on airways and navaids for high- and low-altitude flight, respectively. The division between low altitude and high altitude is usually defined as the altitude that marks transition to flight levels (in the United States , this is taken to be 18,000 feet MSL by convention).