Search results
Results from the WOW.Com Content Network
Falling film evaporators have a number of advantages over their flooded evaporator counterparts. They require a lower charge, as the entire shell (in the case of horizontal evaporators) or all the tubes (in the case of a vertical evaporator) need not be filled with liquid as a thin film is now used to cover the surfaces.
A climbing/falling film plate evaporator is a specialized type of evaporator in which a thin film of liquid is passed over a rising and falling plate to allow the evaporation process to occur. It is an extension of the falling film evaporator , and has application in any field where the liquid to be evaporated cannot withstand extended exposure ...
In many cases, the tubes of a rising film evaporator are usually between 3–10 metres (9.8–32.8 ft) in height with a diameter of between 25–50 millimetres (0.98–1.97 in). Sizing this type of evaporator requires a precise evaluation of the actual level of the liquid inside the tubes and the flow rates of the vapor and film.
diagram of a double-effect falling film evaporator. Condensing vapors from flash tank B1 heat evaporator A2. •1=feed •2=product •3=steam •4=vapors. In chemical engineering, a multiple-effect evaporator is an apparatus for efficiently using the heat from steam to evaporate water. [1]
HVAC (heating, ventilation, and air conditioning) is a major sub discipline of mechanical engineering. The goal of HVAC design is to balance indoor environmental comfort with other factors such as installation cost, ease of maintenance, and energy efficiency. The discipline of HVAC includes a large number of specialized terms and acronyms, many ...
The liquid entering the circulation evaporator will boil in the separator, not on a heating surface, hence minimising fouling, whereas with plate evaporators, boiling will occur on a heating surface. [15] It is for this reason that circulation evaporators are preferred for liquids with a higher tendency to foul.
A vapor-compression evaporator, like most evaporators, can make reasonably clean water from any water source. In a salt crystallizer, for example, a typical analysis of the resulting condensate shows a typical content of residual salt not higher than 50 ppm or, in terms of electrical conductance , not higher than 10 μS/cm .
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.