Search results
Results from the WOW.Com Content Network
BogoMips is a value that can be used to verify whether the processor in question is in the proper range of similar processors, i.e. BogoMips represents a processor's clock frequency as well as the potentially present CPU cache. It is not usable for performance comparisons among different CPUs. [4]
The first fully mechanical analog computer, the Z1, operated at 1 Hz (cycle per second) clock frequency and the first electromechanical general purpose computer, the Z3, operated at a frequency of about 5–10 Hz. The first electronic general purpose computer, the ENIAC, used a 100 kHz clock in its cycling unit. As each instruction took 20 ...
The consumed bandwidth in bit/s, corresponds to achieved throughput or goodput, i.e., the average rate of successful data transfer through a communication path.The consumed bandwidth can be affected by technologies such as bandwidth shaping, bandwidth management, bandwidth throttling, bandwidth cap, bandwidth allocation (for example bandwidth allocation protocol and dynamic bandwidth ...
All higher ratios up to infinity are compressed into the range 100–200%. Ratio bandwidth is often expressed in octaves (i.e., as a frequency level) for wideband applications. An octave is a frequency ratio of 2:1 leading to this expression for the number of octaves, ().
A range of more precise definitions of speed have been prescribed at times, including: "Greater than the primary rate" (which ranged from about 1.5 to 2 Mbit/s) —CCITT in "broadband service" in 1988. [26] "Internet access that is always on and faster than the traditional dial-up access" [24] —US National Broadband Plan of 2009 [27]
Processor / System Dhrystone MIPS or MIPS, and frequency D instructions per clock cycle D instructions per clock cycle per core Year Source LINKS-1 Computer Graphics System (257-processor) 642.5 MIPS at 10 MHz: 2.5: 0.25: 1982 [98] Sega System 16 (4-processor) 16.33 MIPS at 10 MHz: 4.083: 1.020: 1985 [99] Namco System 21 (10-processor) 73.927 ...
In PCs, the CPU's external address and data buses connect the CPU to the rest of the system via the "northbridge". Nearly every desktop CPU produced since the introduction of the 486DX2 in 1992 has employed a clock multiplier to run its internal logic at a higher frequency than its external bus, but still remain synchronous with it. This ...
SIMM modules connect to the computer via an 8-bit- or 32-bit-wide interface. RIMM modules used by RDRAM are 16-bit- or 32-bit-wide. [49] DIMM modules connect to the computer via a 64-bit-wide interface. Some other computer architectures use different modules with a different bus width.