Search results
Results from the WOW.Com Content Network
In analog circuits a high impedance node is one that does not have any low impedance paths to any other nodes in the frequency range being considered.Since the terms low and high depend on context to some extent, it is possible in principle for some high impedance nodes to be described as low impedance in one context, and high impedance in another; so the node (perhaps a signal source or ...
The impedance of a line input is typically around 10 kΩ. When driven by a line output's usual low impedance of 100 to 600 ohms, this forms a "bridging" connection in which most of the voltage generated by the source (the output) is dropped across the load (the input), and minimal current flows due to the load's relatively high impedance.
A high-impedance part of the instrument, such as a string, transmits vibrations through a bridge (intermediate impedance) to a sound board (lower impedance). The soundboard then moves the still lower-impedance air. Without bridge and soundboard, the instrument does not transmit enough sound to the air, and is too quiet to be performed with.
This impedance is purely resistive. This filter, when transformed to a band-pass filter, will have an impedance equal to the nominal impedance at resonance rather than low frequency. This nominal impedance of filters will generally be the same as the nominal impedance of the circuit or cable that the filter is working into. [5]
The electrical purpose of a direct box is to bridge the impedance of the input and output. Most electronic instruments and microphones cannot be plugged directly into the pre-amplifier inputs of mixing boards or recording devices because of impedance mismatch. Instruments are typically high impedance, whereas microphone inputs are low impedance.
For devices with very high output impedances, such as with a guitar pickup or a high-Z mic, a DI box can help with impedance bridging by converting the high output impedances to a lower impedance so as to not require the receiving device to have outrageously high input impedance (which would suffer drawbacks such as increased noise in long ...
Signal flow is the path an audio signal will take from source to the speaker or recording device. Signal flow may be short and simple as in a home audio system or long and convoluted in a recording studio and larger sound reinforcement system as the signal may pass through many sections of a large mixing console, external audio equipment, and even different rooms.
However, it is possible for the low-frequency impedance to be still lower than this. [ 1 ] Due to the reactive nature of a speaker's impedance over the audio band frequencies, giving a speaker a single value for 'impedance' rating is in principle impossible, as one may surmise from the impedance vs. frequency curve above.