Ad
related to: lpt parallel port
Search results
Results from the WOW.Com Content Network
DOS-based systems make the logical parallel ports detected by the BIOS available under device names such as LPT1, LPT2 or LPT3 (corresponding with logical parallel port 1, 2, and 3, respectively). These names derive from terms like Line Print Terminal , Local Print Terminal (both abbreviated as LPT ), or Line Printer.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
LPT is the designation of a parallel port interface on some computer systems. LPT may refer to: Finance. Listed property trust, an Australian real estate ...
The LapLink cable connects five output pins of a parallel port to five input pins on the opposing port for each direction. Due to the lack of internal timing in the parallel ports, synchronization is implemented via software handshaking: four pins are used for data transfer and one is used for synchronization.
LPT parallel port or USB/W QRP2000/UBW/UBW32 N\A N\A N\A USRP B200 [122] Pre-built 70 MHz – 6 GHz 56 MHz 12 12 Yes 56 Msps USB 3.0 Yes Yes Yes Xilinx Spartan 6 XC6SLX75 USRP B210 [123] Pre-built 70 MHz – 6 GHz 56 MHz 12 12 Yes 56 Msps USB 3.0 Yes Yes Yes Xilinx Spartan 6 XC6SLX150 USRP N200 [124] Pre-built DC – 6 GHz
Parallel versus serial communication In data transmission , parallel communication is a method of conveying multiple binary digits ( bits ) simultaneously using multiple conductors. This contrasts with serial communication , which conveys only a single bit at a time; this distinction is one way of characterizing a communications link .
Low Pin Count interface Winbond chip Trusted Platform Module installed on a motherboard, and using the LPC bus. The Low Pin Count (LPC) bus is a computer bus used on IBM-compatible personal computers to connect low-bandwidth devices to the CPU, such as the BIOS ROM (BIOS ROM was moved to the Serial Peripheral Interface (SPI) bus in 2006 [1]), "legacy" I/O devices (integrated into Super I/O ...
This size, with 36 pins and bail locks, is also known as a Centronics connector because of its introduction by Centronics for use with the parallel port of printers, and is standardized as IEEE 1284 type B. Other connectors of this size are also called Centronics connectors. The smaller size has 0.050 inch (1.27 mm) pitch.
Ad
related to: lpt parallel port