enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   Alternately, resin casting may be accomplished with a resin plus a nearly equal amount of a "hardener" liquid (as in many epoxy resin or polyester resin systems), which functionally contains a second polymer, for use in forming a final product plastic which is a copolymer. Copolymers contain two different alternating chemical entities in the ...

3. Fiberglass molding - Wikipedia

   en.wikipedia.org/wiki/Fiberglass_molding

   The mold is a negative image of the component to be made, so the fiberglass will be applied inside the mold, rather than around it. As in the mold-making process, release agent is first applied to the mold. Colored gelcoat is then applied. Layers of fiberglass are then applied, using the same procedure as before.

4. Casting - Wikipedia

   en.wikipedia.org/wiki/Casting

   Plaster and other chemical curing materials such as concrete and plastic resin may be cast using single-use waste molds as noted above, multiple-use 'piece' molds, or molds made of small rigid pieces or of flexible material such as latex rubber (which is in turn supported by an exterior mold). When casting plaster or concrete, the material ...

5. Polymer solution casting - Wikipedia

   en.wikipedia.org/wiki/Polymer_solution_casting

   The polymer solution casting process utilizes a mandrel, or inner diameter mold, that is immersed in a tank of polymer solution or liquid plastic that has been specifically engineered for the process. Due to a combination of thermal and frictional properties, the polymer solution then forms a thin film around the mold. [1]

6. Transfer molding - Wikipedia

   en.wikipedia.org/wiki/Transfer_molding

   Transfer molding (BrE: transfer moulding) is a manufacturing process in which casting material is forced into a mold.Transfer molding is different from compression molding in that the mold is enclosed [1] rather than open to the fill plunger resulting in higher dimensional tolerances and less environmental impact. [2]

7. Compression molding - Wikipedia

   en.wikipedia.org/wiki/Compression_molding

   Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

8. Molding (process) - Wikipedia

   en.wikipedia.org/wiki/Molding_(process)

   A mold or mould is a hollowed-out block that is filled with a liquid or pliable material such as plastic, glass, metal, or ceramic raw material. [2] The liquid hardens or sets inside the mold, adopting its shape. A mold is a counterpart to a cast. The very common bi-valve molding process uses two molds, one for each half of the object.

9. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The matrix is created by the other ingredients in the semi-permanent mold release. Applications of semi-permanent mold release vary from every cycle to once daily applications depending on the compound being molded and the design and quality of the mold. Silicone-based rubber products, however, require a non-silicone based releasing agent.