Search results
Results from the WOW.Com Content Network
This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]
This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances ...
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
A hex key (also, hex wrench, Allen key and Allen wrench, Unbrako or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.