enow.com Web Search

  1. Ads

    related to: 24 double wall culvert pipe coupling home depot 40 gallon gas hot water heater with power vent

Search results

  1. Results from the WOW.Com Content Network
  2. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest fixture from the water heater and closes once hot water contacts the valve to control crossover flow between the hot and cold lines.

  3. Double-walled pipe - Wikipedia

    en.wikipedia.org/wiki/Double-walled_pipe

    Double wall pipes are usually hydrostatically tested, or tested to hold and maintain a target gas pressure before the first use. A different special application of a double-walled pipe is a jacketed pipe, which is used to make high viscosity liquids flow at elevated temperature through the carrier pipe. The outer pipe circulates hot fluids that ...

  4. Tankless water heating - Wikipedia

    en.wikipedia.org/wiki/Tankless_water_heating

    With a central water heater of any type, any cold water standing in the pipes between the heater and the point-of-use is dumped down the drain as hot water travels from the heater. This water wastage can be avoided if a recirculator pump is installed, but at the cost of the energy to run the pump, plus the energy to reheat the water ...

  5. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    In addition to lengths of pipe or tubing, pipe fittings such as valves, elbows, tees, and unions. are used in plumbing systems. [40] Pipe and fittings are held in place with pipe hangers and strapping. Plumbing fixtures are exchangeable devices that use water and can be connected to a building's plumbing system. They are considered to be ...

  6. Heat trap - Wikipedia

    en.wikipedia.org/wiki/Heat_trap

    Microcirculation on the left: Heated water is rising into the pipe on top of the hot water tank, cooling off on the sides of the pipe and thence circulating back into the tank. Right: Circulation of hot water is inhibited by the loop in the pipe. Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters.

  7. Heating, ventilation, and air conditioning - Wikipedia

    en.wikipedia.org/wiki/Heating,_ventilation,_and...

    The heat can be transferred to the surrounding air using radiators, hot water coils (hydro-air), or other heat exchangers. The radiators may be mounted on walls or installed within the floor to produce floor heat. The use of water as the heat transfer medium is known as hydronics. The heated water can also supply an auxiliary heat exchanger to ...

  8. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    An 80 US gal (300 L; 67 imp gal) electric storage tank water heater was able to have a minimum energy factor of 86% under the pre-2015 standard, while under the 2015 standard, the minimum energy factor for an 80-gallon electric storage tank water heater is now 197%, which is only possible with heat pump technology. This rating measures ...

  9. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  1. Ads

    related to: 24 double wall culvert pipe coupling home depot 40 gallon gas hot water heater with power vent