Search results
Results from the WOW.Com Content Network
A serial port is a serial communication interface through ... use a serial port as a control console for diagnostics, while networking hardware (such as routers ...
The Serial Line Internet Protocol (SLIP) [1] [2] is an encapsulation of the Internet Protocol [a] designed to work over serial ports and router connections. It is documented in RFC 1055 . On personal computers, SLIP has largely been replaced by the Point-to-Point Protocol (PPP), which is better engineered, has more features, and does not ...
As there are only two endpoints on a tunnel, the tunnel is a point-to-point connection and PPP is a natural choice as a data link layer protocol between the virtual network interfaces. PPP can assign IP addresses to these virtual interfaces, and these IP addresses can be used, for example, to route between the networks on both sides of the tunnel.
Later personal computers (and other devices) started to make use of the standard so that they could connect to existing equipment. For many years, an RS-232-compatible port was a standard feature for serial communications, such as modem connections, on many computers (with the computer acting as the DTE). It remained in widespread use into the ...
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
Frequent use of a serial port is for a direct computer-to-computer connection. This requires an adapter called a null modem, which isn't actually a modem in the traditional sense, but rather a connector plug that simply crosses the complementary pins on two serial ports so the two sides can communicate. A null modem typically connects the DTR ...
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
SIMM modules connect to the computer via an 8-bit- or 32-bit-wide interface. RIMM modules used by RDRAM are 16-bit- or 32-bit-wide. [49] DIMM modules connect to the computer via a 64-bit-wide interface. Some other computer architectures use different modules with a different bus width.