Search results
Results from the WOW.Com Content Network
CMOS inverter (a NOT logic gate). Complementary metal–oxide–semiconductor (CMOS, / ˈ s iː m ɒ s /, also US: /-ɔː s / [1]) is a type of metal–oxide–semiconductor field-effect transistor (MOSFET) fabrication process that uses complementary and symmetrical pairs of p-type and n-type MOSFETs for logic functions. [2]
In high performance CMOS (complementary metal–oxide–semiconductor) amplifier circuits, transistors are not only used to amplify the signal but are also used as active loads to achieve higher gain and output swing in comparison with resistive loads. [1] [2] [3] CMOS technology was introduced primarily for digital circuit design.
In NMOS logic, the lower half of the CMOS circuit is used in combination with a load device or pull-up transistor (typically a depletion load or a dynamic load). AOI gates are similarly efficient in transistor–transistor logic (TTL). Examples. CMOS 4000-series logic family: CD4085B = dual 2-2 AOI gate [3] CD4086B = single expandable 2-2-2-2 ...
Schematic of two stages of CMOS inverter, showing input and output voltage-time plots. I on and I off (along with I DG, I SD and I DB components) indicate technologically controlled factors. Credit: Prof. Robert Dutton in CRC Electronic Design Automation for IC Handbook, Vol II, Chapter 25, by permission.
The dynamic (switching) power consumption of CMOS circuits is proportional to frequency. [8] Historically, the transistor power reduction afforded by Dennard scaling allowed manufacturers to drastically raise clock frequencies from one generation to the next without significantly increasing overall circuit power consumption.
Multi-threshold CMOS (MTCMOS) is a variation of CMOS chip technology which has transistors with multiple threshold voltages (V th) in order to optimize delay or power.The V th of a MOSFET is the gate voltage where an inversion layer forms at the interface between the insulating layer (oxide) and the substrate (body) of the transistor.
Diode–transistor logic (DTL) was used in the IBM 608 which was the first all-transistorized computer. Early transistorized computers were implemented using discrete transistors, resistors, diodes and capacitors. The first diode–transistor logic family of integrated circuits was introduced by Signetics in 1962.
A CMOS transistor NAND element. V dd denotes positive voltage.. In CMOS logic, if both of the A and B inputs are high, then both the NMOS transistors (bottom half of the diagram) will conduct, neither of the PMOS transistors (top half) will conduct, and a conductive path will be established between the output and Vss (ground), bringing the output low.