Search results
Results from the WOW.Com Content Network
The upstream static pressure (1) is higher than in the constriction (2), and the fluid speed at "1" is lower than at "2", because the cross-sectional area at "1" is greater than at "2". A flow of air through a pitot tube Venturi meter, showing the columns connected in a manometer and partially filled with water. The meter is "read" as a ...
The upstream volumetric flow rate is lower than the downstream condition because of the higher upstream density. The choked velocity is a function of the upstream pressure but not the downstream. Although the velocity is constant, the mass flow rate is dependent on the density of the upstream gas, which is a function of the upstream pressure.
The Parshall Flume acts essentially as a constriction, a downward step, and then an expansion: the upstream section is uniformly convergent and flat, the throat is a short parallel section that slopes downward, and the downstream section is uniformly diverging and slopes upward to an ending elevation that is less than the upstream starting ...
In hydrology, a Venturi flume is a device used for measuring the rate of flow of a liquid in situations with large flow rates, such as a river. [1] It is based on the Venturi effect, for which it is named. [2] It was first developed by V.M. Cone in Fort Collins, Colorado. [3] The Venturi flume consists of a flume with a constricted section in ...
Orifice plate showing vena contracta. An orifice plate is a thin plate with a hole in it, which is usually placed in a pipe. When a fluid (whether liquid or gaseous) passes through the orifice, its pressure builds up slightly upstream of the orifice [1] but as the fluid is forced to converge to pass through the hole, the velocity increases and the fluid pressure decreases.
A nozzle operates according to the Venturi effect to bring the exhaust gasses to ambient pressure, while forming them into a propulsive jet; if the pressure upstream of the nozzle is high enough, the flow will reach sonic speed . The role of the nozzle in back-pressuring the engine is explained below.
The cone acts as a conditioning device as well as a differential pressure producer. Upstream requirements are between 0–5 diameters compared to up to 44 diameters for an orifice plate or 22 diameters for a Venturi. Because cone meters are generally of welded construction, it is recommended they are always calibrated prior to service.
Diagram of a de Laval nozzle, showing approximate flow velocity (v), together with the effect on temperature (T) and pressure (p) A de Laval nozzle (or convergent-divergent nozzle, CD nozzle or con-di nozzle) is a tube which is pinched in the middle, with a rapid convergence and gradual divergence.