Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
Wheels can also lose traction when surface conditions reduce available traction such as on snow and ice. As an open differential delivers only enough torque to cause the "weakest" wheel to spin, if one drive wheel is stationary on a low traction surface (mud, ice, etc.), the deliverable torque is limited to the traction available on it.
There are four basic parameters that are involved in spin coating: solution viscosity, solid content (density), angular speed, and spin time. [13] A range of thicknesses can be achieved by spin coating. Most commonly the thicknesses range from 1-200 μm. The main properties that affect the thickness of the film are viscosity and spin speed.
They may be the actual, or intended to simulate, the design used on antique vehicles or vintage sports cars. A "spinner wheel" in contemporary usage is a type of hubcap or inner wheel ornament, that spins independently inside of a wheel itself when the vehicle is in motion and continues to spin once the vehicle has come to a stop.
A burnout (also known as a peel out, power brake, or brakestand) is the practice of keeping a vehicle stationary and spinning its wheels, the resultant friction causing the tires to heat up and smoke. While the burnout gained widespread popularity in California, it was first created by Buddy Houston, his brother Melson and David Tatum II at Ted ...
From Wikipedia, the free encyclopedia. Redirect page
Wheel flats on railway vehicles are very evident by a distinct “bang-bang” noise made in time with the speed of the train. It is normally necessary to use a wheel lathe to remove a layer of wheel tread caused by a severe flat spot or cavity, which reduces the operational service life of the wheel and is a major operating cost to the rail ...