Search results
Results from the WOW.Com Content Network
Further the fundamental solutions by Boussinesq and Cerruti are of primary importance for the investigation of frictional contact problems in the (linearly) elastic regime. In railway applications one wants to know the relation between creepage (velocity difference) ξ {\displaystyle \xi } and the friction force F w {\displaystyle F_{w}} .
To demonstrate the paradox, a hypothetical system is constructed where analysis of the system requires assuming the direction of the frictional force. Using that assumption, the system is solved. However, once the solution is obtained, the final direction of motion is determined to contradict the assumed direction of the friction force, leading ...
The normal force and the frictional force are ultimately determined using vector analysis, usually via a free body diagram. In general, process for solving any statics problem with friction is to treat contacting surfaces tentatively as immovable so that the corresponding tangential reaction force between them can be calculated.
A starting point for solving contact problems is to understand the effect of a "point-load" applied to an isotropic, homogeneous, and linear elastic half-plane, shown in the figure to the right. The problem may be either plane stress or plane strain. This is a boundary value problem of linear elasticity subject to the traction boundary conditions:
Stick–slip can be modeled as a mass coupled by an elastic spring to a constant drive force (see the model sketch). The drive system V applies a constant force, loading spring R and increasing the pushing force against load M. This force increases until retarding force from the static friction coefficient between load and floor is exceeded.
Due to frictional force, the velocity decreases in proportion to the acting frictional force. While in a simple undriven harmonic oscillator the only force acting on the mass is the restoring force, in a damped harmonic oscillator there is in addition a frictional force which is always in a direction to oppose the motion.
Belt friction is a term describing the friction forces between a belt and a surface, such as a belt wrapped around a bollard.When a force applies a tension to one end of a belt or rope wrapped around a curved surface, the frictional force between the two surfaces increases with the amount of wrap about the curved surface, and only part of that force (or resultant belt tension) is transmitted ...
Essentially, the object in the system is vibrating back and forth around an equilibrium point. A system being acted upon by Coulomb damping is nonlinear because the frictional force always opposes the direction of motion of the system as stated earlier. And because there is friction present, the amplitude of the motion decreases or decays with ...