enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   The hex head is used to drive the bolt into the countersunk hole, then either a wrench or hammer is used to break the shank and hex head from the flat head, or it is driven until the driving head shears off. Either method leaves only a smooth bolt head exposed. This type of bolt is commonly used with prison door locks, automobile ignition ...

4. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2 -inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8 -inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming ( S&D ) bits, whose sets run from 9 ⁄ 16 -inch (14 mm) to 1 + 1 ⁄ 2 -inch (38 mm) drill ...

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   carriage bolt: cup head bolt, coach bolt: A carriage bolt, also known as a coach bolt, has a domed or countersunk head, with a shank topped by a short square section under the head. Unlike "regular" bolts, a carriage bolt has a smooth head that does not accept tools; instead, counter-rotation is provided by the square section of shank.

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   An assortment of screws, and a US quarter for size comparison A wood screw: a) head; b) non-threaded shank; c) threaded shank; d) tip The six classical simple machines. A screw is an externally helical threaded fastener capable of being tightened or released by a twisting force to the head.

8. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   For production machine tools, the shank type is usually one of the following: a standard taper (such as Morse or Brown & Sharpe), a straight round shank to be held by a collet, or a straight round shank with a flat for a set screw, to be held by a solid toolholder.

9. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Fractional drill bit set by Craftsman. Fractional-inch drill bit sizes are still in common use in the United States and in any factory (around the globe) that makes inch-sized products for the U.S. market. ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments.