enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   A piece added at the foot to create an overhang or change the roof pitch is called a sprocket, or coyau in French. The projecting piece on the gable of a building forming an overhang is called a lookout. A rafter can be reinforced with a strut, principal purlin, collar beam, or, rarely, an auxiliary rafter (see below). Rafter types include:

3. Open web steel joist - Wikipedia

   en.wikipedia.org/wiki/Open_web_steel_joist

   The LH- and DLH-Series have been designed for the purpose of extending the use of joists to spans and loads in excess of those covered by Open Web Steel Joists, K-Series. LH-Series Joists have been standardized in depths from 18 inches (460 mm) through 48 inches (1,200 mm), for spans through 96 feet (29,000 mm).

4. Block-stacking problem - Wikipedia

   en.wikipedia.org/wiki/Block-stacking_problem

   The first nine blocks in the solution to the single-wide block-stacking problem with the overhangs indicated. In statics, the block-stacking problem (sometimes known as The Leaning Tower of Lire (Johnson 1955), also the book-stacking problem, or a number of other similar terms) is a puzzle concerning the stacking of blocks at the edge of a table.

5. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

6. Fascia (architecture) - Wikipedia

   en.wikipedia.org/wiki/Fascia_(architecture)

   Fascia (/ ˈ f eɪ ʃ ə /) is an architectural term for a vertical frieze or band under a roof edge, or which forms the outer surface of a cornice, visible to an observer. [ 1 ] Typically consisting of a wooden board, unplasticized PVC (uPVC), or non-corrosive sheet metal, many of the non-domestic fascias made of stone form an ornately carved ...

7. Glossary of structural engineering - Wikipedia

   en.wikipedia.org/wiki/Glossary_of_structural...

   Rafter – is one of a series of sloped structural members that extend from the ridge or hip to the wall plate, downslope perimeter or eave, and that are designed to support the roof deck and its associated loads. [30] A pair of rafters is called a couple. In home construction, rafters are normally made of wood. Exposed rafters are a feature of ...

8. Lift slab construction - Wikipedia

   en.wikipedia.org/wiki/Lift_slab_construction

   Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...

9. Eaves - Wikipedia

   en.wikipedia.org/wiki/Eaves

   Eaves overhang, shown here with a bracket system of modillions The eaves are the edges of the roof which overhang the face of a wall and, normally, project beyond the side of a building. The eaves form an overhang to throw water clear of the walls and may be highly decorated as part of an architectural style , such as the Chinese dougong ...