enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Disconnector - Wikipedia

   en.wikipedia.org/wiki/Disconnector

   In electrical engineering, a disconnector, disconnect switch or isolator switch is a type of switching device with visible contacts, used to ensure that an electrical circuit is completely de-energized for service or maintenance.

3. Fuse (electrical) - Wikipedia

   en.wikipedia.org/wiki/Fuse_(electrical)

   A fuse consists of a metal strip or wire fuse element, of small cross-section compared to the circuit conductors, mounted between a pair of electrical terminals, and (usually) enclosed by a non-combustible housing. The fuse is arranged in series to carry all the charge passing through the protected circuit. The resistance of the element ...

4. BS 7671 - Wikipedia

   en.wikipedia.org/wiki/BS_7671

   Entitled ‘Rules and Regulations for the prevention of Fire Risks Arising from Electric Lighting’, and known as the "Wiring Rules". Two core cable, line and neutral, no earth. Protection was a re-wirable fuse. 1888: 2nd: IEE: Entitled 'Wiring Rules & Regulations in Buildings. [verification needed] 1897: 3rd: IEE

5. IEC 60269 - Wikipedia

   en.wikipedia.org/wiki/IEC_60269

   In electrical engineering, IEC 60269 is a set of technical standards for low-voltage power fuses. [1] The standard is in four volumes, which describe general requirements, fuses for industrial and commercial applications, fuses for residential applications, and fuses to protect semiconductor devices.

6. Utilization categories - Wikipedia

   en.wikipedia.org/wiki/Utilization_categories

   DC-6: Switching of incandescent lamps: 60947-4-1 DC-12: Control of resistive loads and solid state loads with opto-coupler isolation: 60947-5-1 60947-5-2 DC-13: Control of D.C. electromagnetics: 60947-5-1 60947-5-2 DC-14: Control of D.C. electromagnetic loads having economy resistors in the circuit: 60947-5-1 DC-20: Connecting and disconnecting ...

7. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.