enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dip moulding - Wikipedia

   en.wikipedia.org/wiki/Dip_moulding

   The plastic can be heated or not according to their physical state at room temperature. In the case of a powder, the plastic is fluidized. The following steps constitute the dip moulding process: mould heating; heated mould dipped into the plastic material; removal of the mould; excess drainage;

3. Mold control and prevention (library and archive) - Wikipedia

   en.wikipedia.org/wiki/Mold_control_and...

   Mold is a dangerous library pest because of the damage it causes to the collections. Mold thrives off of paper and books; these objects provide the fungi a source of nutrition, namely the sugar and starches present in the cellulose materials. [6] Mold feeds on cloth, leather, glues, adhesives, cellulose starch and starches in the sizing.

4. Flash (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Flash_(manufacturing)

   Flash, also known as flashing, is excess material attached to a molded, forged, or cast product, which must usually be removed. This is typically caused by leakage of the material between the two surfaces of a mold (beginning along the parting line [1]) or between the base material and the mold in the case of overmolding.

5. Is This Toxic Mold? How To Know If It's In Your House—And Why ...

   www.aol.com/toxic-mold-know-house-why-184500544.html

   Mold illness isn’t easy to define, and the path from home mold growth to debilitating chronic health symptoms is complicated. But often the story starts like this: Moisture in a home can cause ...

6. Draft (engineering) - Wikipedia

   en.wikipedia.org/wiki/Draft_(engineering)

   Consider the fabrication of a hollow plastic box, without lid. Once the plastic has hardened around the mold, the mold must be removed. As the plastic hardens, it may contract slightly. By tapering the sides of the mold by an appropriate "draft angle", for instance 2° (two degrees), the mold will be easier to remove.

7. Sprue (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Sprue_(manufacturing)

   The gate is the location at which the molten plastic enters the mold cavity and is often evidenced by a small nub or projection (the "gate mark") on the molded piece. Many scale-model kits are made from injection-molded plastic. Hobbyists typically remove the parts of a model kit from the runner using a sharp craft knife or razor saw. The ...