enow.com Web Search

  1. Ads

    related to: 3 8 high temp tubing

Search results

  1. Results from the WOW.Com Content Network
  2. Heat-shrink tubing - Wikipedia

    en.wikipedia.org/wiki/Heat-shrink_tubing

    Heat-shrink tubing (or, commonly, heat shrink or heatshrink) is a shrinkable plastic tube used to insulate wires, providing abrasion resistance and environmental protection for stranded and solid wire conductors, connections, joints and terminals in electrical wiring.

  3. Borosilicate glass - Wikipedia

    en.wikipedia.org/wiki/Borosilicate_glass

    The softening point (temperature at which viscosity is approximately 10 7.6 poise) of type 7740 Pyrex is 820 °C (1,510 °F). [8] Borosilicate glass is less dense (about 2.23 g/cm 3) than typical soda–lime glass due to the low atomic mass of boron. Its mean specific heat capacity at constant pressure (20–100 °C) is 0.83 J/(g⋅K), roughly ...

  4. Annealing (materials science) - Wikipedia

    en.wikipedia.org/wiki/Annealing_(materials_science)

    The temperature range for process annealing ranges from 260 °C (500 °F) to 760 °C (1400 °F), depending on the alloy in question. This process is mainly suited for low-carbon steel. The material is heated up to a temperature just below the lower critical temperature of steel.

  5. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    For example, DN20 is the size for copper pipe with an outside diameter of 19.05 mm or 3 ⁄ 4 inch. While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a ...

  6. Cross-linked polyethylene - Wikipedia

    en.wikipedia.org/wiki/Cross-linked_polyethylene

    A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.

  7. Tygon tubing - Wikipedia

    en.wikipedia.org/wiki/Tygon_Tubing

    It is often used in incubators and as a replacement for rubber tubing for Bunsen burners. This material is produced in vacuum sizes and can withstand a full vacuum at room temperature. It is a thermoplastic PVC-based material with plasticizer. [3] Tygon R-1000 Ultra-Soft Tubing is used in general laboratory

  1. Ads

    related to: 3 8 high temp tubing