Search results
Results from the WOW.Com Content Network
Each IOS Image therefore include a feature set, which determine the command-line interface (CLI) commands and features that are available on different Cisco devices. Upgrading to another feature set therefore entails the installation of a new IOS image on the networking device and reloading the IOS operating system.
Each Cisco device that supports CDP stores the information received from other devices in a table that can be viewed using the show cdp neighbors command. This table is also accessible via Simple Network Management Protocol (SNMP). The CDP table information is refreshed each time an announcement is received, and the hold time for that entry is ...
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
Enhanced Interior Gateway Routing Protocol (EIGRP) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers.
The Dynamic Trunking Protocol (DTP) is a proprietary link layer protocol developed by Cisco Systems for the purpose of negotiating trunking on a link between two VLAN-aware switches, and for negotiating the type of trunking encapsulation to be used. VLAN trunks formed using DTP may utilize either IEEE 802.1Q or Cisco ISL trunking protocols. [1]
On Cisco network devices running CatOS, a single switch module may only be configured to run in either LACP or PAgP modes. Cisco devices that run IOS (native and/or non-hybrid mode boxes) support individual port configuration for LACP and are not restricted to per-module settings as with CatOS.
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination. The sum of ...
The Network Configuration Protocol (NETCONF) is a network management protocol developed and standardized by the IETF. It was developed in the NETCONF working group [1] and published in December 2006 as RFC 4741 [2] and later revised in June 2011 and published as RFC 6241. [3] The NETCONF protocol specification is an Internet Standards Track ...