enow.com Web Search

  1. Ads

    related to: replacing flame sensor in furnace

Search results

  1. Results from the WOW.Com Content Network
  2. Flame rectification - Wikipedia

    en.wikipedia.org/wiki/Flame_rectification

    Flame rectification is a phenomenon in which a flame can act as an electrical rectifier. The effect is commonly described as being caused by the greater mobility of electrons relative to that of positive ions within the flame, [ 1 ] and the asymmetric nature of the electrodes used to detect the phenomenon.

  3. Flame detector - Wikipedia

    en.wikipedia.org/wiki/Flame_detector

    A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection. Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system. When used in ...

  4. Industrial furnace - Wikipedia

    en.wikipedia.org/wiki/Industrial_furnace

    A furnace can be lit by a small pilot flame or in some older models, by hand. Most pilot flames nowadays are lit by an ignition transformer (much like a car's spark plugs). The pilot flame in turn lights up the main flame. The pilot flame uses natural gas while the main flame can use both diesel and natural gas. When using liquid fuels, an ...

  5. Gas detector - Wikipedia

    en.wikipedia.org/wiki/Gas_detector

    The first gas detector in the industrial age was the flame safety lamp (or Davy lamp) was invented by Sir Humphry Davy (of England) in 1815 to detect the presence of methane (firedamp) in underground coal mines. The flame safety lamp consisted of an oil flame adjusted to specific height in fresh air.

  6. Flame ionization detector - Wikipedia

    en.wikipedia.org/wiki/Flame_ionization_detector

    Flame ionization detectors are used very widely in gas chromatography because of a number of advantages. Cost: Flame ionization detectors are relatively inexpensive to acquire and operate. Low maintenance requirements: Apart from cleaning or replacing the FID jet, these detectors require little maintenance.

  7. Central heating - Wikipedia

    en.wikipedia.org/wiki/Central_heating

    This limit controller may shut the furnace off if the blower fails or if something is blocking the air flow. The heated air is then sent back through the home through supply ducts. In larger commercial applications, central heating is provided through an air handler which incorporates similar components as a furnace but on a larger scale.

  1. Ads

    related to: replacing flame sensor in furnace