enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flame detector - Wikipedia

   en.wikipedia.org/wiki/Flame_detector

   A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection.Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system.

3. Flame cleaning - Wikipedia

   en.wikipedia.org/wiki/Flame_cleaning

   Flame cleaning, also known as flame gouging, [1] is the process of cleaning a structural steel surface by passing an intensely hot oxyacetylene flame over it. Mill scale and rust are removed by the reducing effect of the flame and the action of the heat, leaving the surface in a condition suitable for wire brushing and painting.

4. Flame rectification - Wikipedia

   en.wikipedia.org/wiki/Flame_rectification

   Flame rectification is a phenomenon in which a flame can act as an electrical rectifier. The effect is commonly described as being caused by the greater mobility of electrons relative to that of positive ions within the flame, [1] and the asymmetric nature of the electrodes used to detect the phenomenon. [2] [clarification needed]

5. Flame supervision device - Wikipedia

   en.wikipedia.org/wiki/Flame_supervision_device

   For gas appliances, a flame supervision device (FSD) – alternative name: flame failure device (FFD) – is a general term for any device designed to stop flammable gas going to the burner of a gas appliance if the flame is extinguished. This is to prevent a dangerous buildup of gas within the appliance, its chimney or the room. [1]

6. Pilot light - Wikipedia

   en.wikipedia.org/wiki/Pilot_light

   In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways:

7. Industrial furnace - Wikipedia

   en.wikipedia.org/wiki/Industrial_furnace

   A furnace can be lit by a small pilot flame or in some older models, by hand. Most pilot flames nowadays are lit by an ignition transformer (much like a car's spark plugs). The pilot flame in turn lights up the main flame. The pilot flame uses natural gas while the main flame can use both diesel and natural gas. When using liquid fuels, an ...