Search results
Results from the WOW.Com Content Network
Cross-section of 80/20 T-slotted profiles, 10 and 15 series A bicycle trailer for bike-trekking with three Euroboxes and aluminium profile framing T-slot structural framing is a framing system consisting of lengths of square or rectangular extruded aluminium, typically 6105-T5 aluminium alloy , with a T-slot down the centerline of one or more ...
Extrusion is a process used to create objects of a fixed cross-sectional profile by pushing material through a die of the desired cross-section. Its two main advantages over other manufacturing processes are its ability to create very complex cross-sections; and to work materials that are brittle, because the material encounters only ...
In steel extrusions, the depth of an indentation should be no greater than its width at its narrowest point. This is necessary to provide sufficient strength in the tongue portion of the extruding die. In copper alloys, magnesium, and aluminum, the depth of an indentation may be greater since extrusion pressures are lower.
When deciding the wall thickness of any extrusion profile, strength and cost efficiency are two main factors. Though Uniform wall thicknesses are most easy to manufacture, wall thickness can easily be varied as necessary within a profile. If changes in the wall thickness are unavoidable, make them as gradual rather than abrupt variations.
T1 temper 6063 has an ultimate tensile strength of at least 120 MPa (17,000 psi) in thicknesses up to 12.7 mm (0.5 in), and 110 MPa (16,000 psi) from 13 to 25 mm (0.5 to 1 in) thick, and yield strength of at least 62 MPa (9,000 psi) in thickness up to 13 millimetres (0.5 in) and 55 MPa (8,000 psi) from 13 mm (0.5 in) thick.
ASTM B 221: Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes; EN 573-3: Aluminium and aluminium alloys. Chemical composition and form of wrought products. Chemical composition and form of products; EN 755-2: Aluminium and aluminium alloys. Extruded rod/bar, tube and profiles. Mechanical ...
ASTM B 221: Standard Specification for Aluminium and Aluminium-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes; EN 573-3: Aluminium and aluminium alloys. Chemical composition and form of wrought products. Chemical composition and form of products; EN 755-2: Aluminium and aluminium alloys. Extruded rod/bar, tube and profiles. Mechanical ...
6061 is an alloy used in the production of extrusions—long constant–cross-section structural shapes produced by pushing metal through a shaped die. Cold and Hot Stamping. 6061 sheet in the T4 condition can be formed with limited ductility in the cold state.