Ad
related to: 7 positions of the trombonetomplay.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Trombone first position harmonic series, "where additional overtones may be used to stretch the upper range a bit higher." [18] Trombone seventh position harmonic series. [18] As with all brass instruments, progressive tightening of the lips and increased air pressure allow the player to move to different partial in the harmonic series.
The trombone produces notes within its range by extending the main slide to different positions. In first position, the length of the bore is at its shortest; seventh position puts the slide at its furthest extension, at the edge of the inner slide's stockings. (These are sections of slightly greater diameter at the ends of the inner slide tubes.)
The bore of an alto trombone is intermediate between a trumpet and a tenor trombone, and similar to that of a small-bore tenor, usually around 0.450 to 0.500 inches (11.4 to 12.7 mm) with a 6 + 1 ⁄ 2 or 7 inches (17 or 18 cm) bell.
The Superbone can be played as a slide trombone, a valve trombone, or in combination. Using the slide and valves in combination requires the slide positions to be adjusted, just as when using the trigger of an F attachment on a tenor or bass trombone. Using the slide with the first and third valves engaged has the same effect as using an F ...
The contrabass trombone (German: Kontrabassposaune, Italian: trombone contrabbasso) is the lowest-pitched instrument in the trombone family of brass instruments.While modern instruments are pitched in 12 ft (12 ′) F with a single slide, the first practical contrabass trombones appeared in the mid-19th century built in 18 ′ B♭ an octave below the tenor trombone with a double slide.
The piccolo trombone in B♭ is an octave above the soprano. It is essentially a piccolo trumpet with a slide instead of valves, and is used with a piccolo trumpet mouthpiece. [14] Bore sizes are 0.460 inches (11.7 mm) or smaller, with bells approximately 4 inches (10 cm) in diameter.
Non-compensating instruments and trombones must not use the third position or valve combination because it is not in tune; other combinations must be altered drastically. Some musicians prefer to extend the tablature numbering system to 12 or more; others prefer a symbol to indicate a lesser-used, longer valve.
Brass instruments still rely heavily on the overtone series to produce notes: the tuba typically has 3-4 valves, the tenor trombone has 7 slide positions, the trumpet has 3 valves, and the French horn typically has 4 valves. Each instrument can play (within their respective ranges) the notes of the overtone series in different keys with each ...
Ad
related to: 7 positions of the trombonetomplay.com has been visited by 10K+ users in the past month