Search results
Results from the WOW.Com Content Network
This is a list of the power supply systems that are, or have been, used for railway electrification. Note that the voltages are nominal and vary depending on load and distance from the substation. As of 2023 many trams and trains use on-board solid-state electronics to convert these supplies to run three-phase AC traction motors.
All power comes from general electricity suppliers. Although in this region there is, in principle, no requirement for traction power lines, there is a 132 kV-single AC power grid for railway power supply in Central Sweden (see Electric power supply system of railways in Sweden). In Norway, there is a small 55 kV single phase AC network for ...
Various railway electrification systems in the late nineteenth and twentieth centuries utilised three-phase, rather than single-phase electric power delivery due to ease of design of both power supply and locomotives. These systems could either use standard network frequency and three power cables, or reduced frequency, which allowed for return ...
A traction substation, traction current converter plant, rectifier station or traction power substation (TPSS) is an electrical substation that converts electric power from the form provided by the electrical power industry for public utility service to an appropriate voltage, current type and frequency to supply railways, trams (streetcars) or ...
A China Railway KD 25K generator car at Beijing railway station. A head-end power car (also called a generator car) is a rail car that supplies head-end power ("HEP"). Since most modern locomotives supply HEP, they are now mostly used by heritage railways that use older locomotives, or by railroad museums that take their equipment on excursions ...
Trolley pole wheel on top of the trolley pole of Twin City Rapid Transit Company No. 1300. A current collector (often called a "pickup") is a device used in trolleybuses, trams, electric locomotives and EMUs to carry electric power from overhead lines, electric third rails, or ground-level power supplies to the electrical equipment of the vehicles.
This category does not cover railways with a single-phase (or DC) supply which is converted to three-phase on the locomotive or power car, e.g., most railway equipment from the 1990s and earlier using solid-state converters.
In Nazi Germany, a railway system with a 3,000 mm (9 ft 10 + 1 ⁄ 8 in) gauge width was planned. For this Breitspurbahn railway system, electrification with a voltage of 100 kV taken from a third rail was considered, in order to avoid damage to overhead wires from oversize rail-mounted anti-aircraft guns. However, such a power system would not ...