Search results
Results from the WOW.Com Content Network
Whether speakers are wired in parallel or in series affects the impedance of the system. Two 8 ohm speakers wired in parallel have 4-ohm impedance. Guitarists who connect multiple cabinets to an amplifier must consider the amp's minimum impedance. Parallel vs. series also affects tone and sound. Speakers wired in parallel slightly dampen[s] and ...
The image shows two identical amplifiers A1 and A2 connected in parallel configuration. This configuration is often used when a single amplifier is incapable of being operated into a low impedance load or dissipation per amplifier is to be reduced without increasing the load impedance or reducing power delivered to the load. For example, if two ...
A series circuit with a voltage source (such as a battery, or in this case a cell) and three resistance units. Two-terminal components and electrical networks can be connected in series or parallel. The resulting electrical network will have two terminals, and itself can participate in a series or parallel topology.
Larger multiples will usually be series/parallel to maintain an impedance of 4 to 8 ohms. Many cabinets contain parallel input/outputs on the rear panel, so that one speaker cab can be plugged into the amp head, and then a second cabinet can be plugged into the first cabinet; as this "daisy-chaining" approach is wired in parallel, plugging in a ...
A speaker L pad is a special configuration of rheostats used to control volume while maintaining a constant load impedance on the output of the audio amplifier. [1] It consists of a parallel and a series rheostat connected in an "L" configuration.
Reducing the output impedance of power pentodes (such as the EL34) in a common-cathode configuration. The impedance of the loudspeaker on the secondary coil of the transformer will be transformed to a higher impedance on the primary coil in the circuit of the power pentodes by the square of the turns ratio, which forms the impedance scaling factor.
Series and parallel are, in fact, the 2-terminal versions of star and polygon topology. A common simple topology that cannot be solved by series and parallel combinations is the input impedance to a bridge network (except in the special case when the bridge is in balance). [9]
Care must be taken not to overload the amplifier by keeping the total speaker impedance above the amplifier's rated minimum impedance. This can be done by wiring the speakers in series, as opposed to parallel (though if the impedance is too high, power transfer is inefficient), with impedance-matching transformers , or by using constant-voltage ...