enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Baseboard - Wikipedia

   en.wikipedia.org/wiki/Baseboard

   Prepainted baseboards can be made from a single piece or finger jointed wood, often softwoods, while hardwoods are either lacquered, or raw for staining and made from a single piece of wood. MDF (medium-density fiberboard) is a common material used for baseboard trim and molding .

3. Molding (decorative) - Wikipedia

   en.wikipedia.org/wiki/Molding_(decorative)

   Baseboard, "base moulding" or "skirting board": Used to conceal the junction of an interior wall and floor, to protect the wall from impacts and to add decorative features. A "speed base" makes use of a base "cap moulding" set on top of a plain 1" thick board, however there are hundreds of baseboard profiles. Baton: See Torus

4. Ethylene-vinyl acetate - Wikipedia

   en.wikipedia.org/wiki/Ethylene-vinyl_acetate

   The EVA copolymer which is based on a medium proportion of VA (approximately 4 to 30%) is referred to as thermoplastic ethylene-vinyl acetate copolymer and is a thermoplastic elastomer material. It is not vulcanized but has some of the properties of a rubber or of plasticized polyvinyl chloride particularly at the higher end of the range. Both ...

5. Quarter round - Wikipedia

   en.wikipedia.org/wiki/Quarter_round

   A variation is a base shoe, a quarter of an ellipse. [1] Most quarter round is of small gauge and relatively flexible. It is typically used as a decorative build-up element in mantels and other architectural features, and at the lower edge of baseboard to hide any gaps between it and a floor. Base shoe is used similarly in flooring applications.

6. Compression molding - Wikipedia

   en.wikipedia.org/wiki/Compression_molding

   Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

7. Thermoplastic vulcanizates - Wikipedia

   en.wikipedia.org/wiki/Thermoplastic_vulcanizates

   Thermoplastic vulcanizates were first reported in 1962 by A.M. Gessler and W.H. Haslett. [4] In 1973, W.K. Fisher reported the dynamic vulcanization process through his prior work on polypropylene and EPDM rubber-based TPVs with peroxides as a cross-linking agent.