Search results
Results from the WOW.Com Content Network
The stationary (outer) swashplate is mounted on the main rotor mast and is connected to the cyclic and collective controls by a series of pushrods. It is able to tilt in all directions and move vertically. The rotating (inner) swashplate is mounted to the stationary swashplate by means of a bearing and is allowed to rotate with the main rotor mast.
A bearing compass, is a nautical instrument used to determine the bearing of observed objects. (Bearing: angle formed by the north and the visual to a certain object in the sea or ashore). Used in navigation to determine the angle between the direction of an object and the magnetic north or, indirectly relative to another reference point.
Key: 1. Forestay 2. Shroud 3. (Spreaders) 4. Backstay 5. Inner forestay 6. Sidestay 7. (Boom) 8. Running backstays Standing rigging on a square-rigged vessel (illustrated left), which supports a mast comprising three steps: main, top, and topgallant (illustrated right). The shrouds support each section laterally and the stays support each, fore ...
Sprit topmast: a small mast set on the end of the bowsprit (discontinued after the early 18th century); not usually counted as a mast, however, when identifying a ship as "two-masted" or "three-masted" Fore-mast: the mast nearest the bow, or the mast forward of the main-mast. [3] As it is the furthest afore, it may be rigged to the bowsprit.
A guyed radio mast. A guyed mast is a tall thin vertical structure that depends on guy lines (diagonal tensioned cables attached to the ground or a base) for stability. The mast itself has the compressive strength to support its own weight, but does not have the shear strength to stand unsupported or bear loads.
Many mast-aft rigs utilize a small mainsail and multiple staysails that can resemble some cutter rigs. A cutter is a single masted vessel, differentiated from a sloop either by the number of staysails, with a sloop having one and a cutter more than one, or by the position of the mast, with a cutter's mast being located between 50% and 70% of the way from the aft to the front of the sailplan ...
Chairman of the Joint Chiefs of Staff Admiral Mike Mullen putting good luck pieces into a box, during a mast stepping ceremony for the USS Dewey (DDG-105) at Northrop Grumman Shipbuilding in Pascagoula, Mississippi in 2009. Mast stepping is the process of raising the mast of a boat. It may be a ceremonial occasion on a new boat, a necessary ...
The helicopter rotor is powered by the engine, through the transmission, to the rotating mast. The mast is a cylindrical metal shaft that extends upward from—and is driven by—the transmission. At the top of the mast is the attachment point (colloquially called a Jesus nut) for the rotor blades called the hub