Search results
Results from the WOW.Com Content Network
In this circuit, the base terminal of the transistor serves as the input, the collector is the output, and the emitter is common to both (for example, it may be tied to ground reference or a power supply rail), hence its name. The analogous FET circuit is the common-source amplifier, and the analogous tube circuit is the common-cathode amplifier.
The load line diagram at right is for a resistive load in a common emitter circuit. The load line shows how the collector load resistor (R L ) constrains the circuit voltage and current. The diagram also plots the transistor's collector current I C versus collector voltage V CE for different values of base current I base .
In this circuit, the base terminal of the transistor serves as the input, the emitter is the output, and the collector is common to both (for example, it may be tied to ground reference or a power supply rail), hence its name.
In electronics, emitter-coupled logic (ECL) is a high-speed integrated circuit bipolar transistor logic family. ECL uses an overdriven bipolar junction transistor (BJT) differential amplifier with single-ended input and limited emitter current to avoid the saturated (fully on) region of operation and the resulting slow turn-off behavior. [ 2 ]
An amplifier circuit, a common-emitter configuration with a voltage-divider bias circuit The common-emitter amplifier is designed so that a small change in voltage ( V in ) changes the small current through the base of the transistor whose current amplification combined with the properties of the circuit means that small swings in V in produce ...
The fast operation of CML circuits is mainly due to their lower output voltage swing compared to the static CMOS circuits, as well as the very fast current switching taking place at the input differential pair transistors. One of the primary requirements of a current-mode logic circuit is that the current bias transistor must remain in the ...
The easiest way to tell if a FET is common source, common drain, or common gate is to examine where the signal enters and leaves. The remaining terminal is what is known as "common". In this example, the signal enters the gate, and exits the drain. The only terminal remaining is the source. This is a common-source FET circuit.
The heart of an I2L circuit is the common emitter open collector inverter. Typically, an inverter consists of an NPN transistor with the emitter connected to ground and the base biased with a forward current from the current source. The input is supplied to the base as either a current sink (low logic level) or as a high-z floating condition ...