Search results
Results from the WOW.Com Content Network
Fig. 4 Top: Small-signal BJT cascode using hybrid-pi model Bottom: Equivalent circuit for BJT cascode using amplifier low-frequency parameters. The g-parameters found in the above formulas can be used to construct a small-signal voltage amplifier with the same gain, input and output resistance as the original cascode (an equivalent circuit).
For R S values in the vicinity of r E the amplifier is transitional between voltage amplifier and current buffer. For R S ≫ r E the driver representation as a Thévenin source should be replaced by representation with a Norton source. The common base circuit stops behaving like a voltage amplifier and behaves like a current follower, as ...
For example, a common base may be used as a current buffer at the output of a common emitter stage, forming a cascode. This will typically reduce the Miller effect and increase the bandwidth of the amplifier. Alternatively, a voltage buffer may be used before the amplifier input, reducing the effective source impedance seen by the input terminals.
Using a cascode configuration, which inserts a low input impedance current buffer (e.g. a common base amplifier) between the transistor's collector and the load. This configuration holds the transistor's collector voltage roughly constant, thus making the base to collector gain zero and hence (ideally) removing the Miller effect.
The cascode (a contraction of the phrase cascade to cathode) is a two-stage amplifier composed of a transconductance amplifier followed by a current buffer. In valve circuits, the cascode is often constructed from two triodes connected in series, with one operating as a common grid and thus acting as a voltage regulator , providing a nearly ...
Figure 2: A negative-feedback amplifier. The circuit can be explained by viewing the transistor as being under the control of negative feedback.From this viewpoint, a common-collector stage (Fig. 1) is an amplifier with full series negative feedback.
Consumer Reports is a United States-based non-profit organization which conducts product testing and product research to collect information to share with consumers so that they can make more informed purchase decisions in any marketplace.
The only terminal remaining is the source. This is a common-source FET circuit. The analogous bipolar junction transistor circuit may be viewed as a transconductance amplifier or as a voltage amplifier. (See classification of amplifiers). As a transconductance amplifier, the input voltage is seen as modulating the current going to the load.