Search results
Results from the WOW.Com Content Network
Aerolux Light Corporation was a manufacturer of artful gas-discharge light bulbs from the 1930s through the 1970s. [1] Aerolux made these bulbs in a factory in New York City . US Patents dating back to the 1930s describe the design and construction of these bulbs.
To enable rapid access of specific stars in the catalogue, WCSTools software numbers each star using its Guide Star region number (0001 to 9537) and a five-digit star number within each region, separated by a decimal point. sty2 lists Tycho-2 stars by number or sky region. imty2 lists the Tycho-2 stars within an IRAF or FITS image using the world coordinate system defined in its header.
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
Tung-Sol Lamp Works was licensed to produce lamps in tungsten-filament from General Electric through royalty-free rights for their patent. Tung-Sols' license was a B license allowing only paying a quota and percentage of production for large or small bulb manufacturing to General Electric without exports of goods.
Light guide LEDs using plastic light guides on a network switch The technology was rendered obsolete by the development of light-emitting diodes (LED) in the 1970s, though lightguide tubes are still used in electronics manufacturing, in situations where it is difficult to place an LED in the appropriate physical location on a display or bezel.
Cameras with focal-plane shutters—even if they had PC connectors with X, F, M, or S-sync delays ("xenon sync" with zero delay and flashbulbs with peak delays of 5, 20, and 30 ms)—could not be used at speeds that attenuated guide numbers with most types of flashbulbs because their light curves were characterized by rapid rise and fall rates; the second shutter curtain would begin wiping ...
Telescoping in mechanics describes the movement of one part sliding out from another, lengthening an object (such as a telescope or the lift arm of an aerial work platform) from its rest state. [1] In modern equipment this can be achieved by a hydraulics , but pulleys are generally used for simpler designs such as extendable ladders and amateur ...
Watercraft navigation lights must permit other vessels to determine the type and relative angle of a vessel, and thus decide if there is a danger of collision. In general, sailing vessels are required to carry a green light that shines from dead ahead to 2 points (22 + 1 ⁄ 2 °) abaft [note 1] the beam on the starboard side (the right side from the perspective of someone on board facing ...