Search results
Results from the WOW.Com Content Network
A portable magnetic drilling machine is faster and more portable alternative to hole making machines such as the drill press, and is more accurate than a hand drill. A portable magnetic drilling machine is used on steel or other magnetic materials. It gives an accuracy of 0.01 mm to 0.05mm in steel or other magnetic material. The drill bits ...
A drill press is a drilling machine suitable for quick and easy drilling of straight holes, countersinking or counterboring that are perpendicular to both directions of a table surface. In comparison, it is more difficult and less repeatable to drill perpendicularly with a hand-held drill.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
A drill press Drill press (then called a boring machine) boring wooden reels for winding barbed wire, 1917. A drill press (also known as a pedestal drill, pillar drill, or bench drill) is a style of drill that may be mounted on a stand or bolted to the floor or workbench. Portable models are made, some including a magnetic base.
Bridgeport manual milling machines came in many types and sizes over the years, including (but not limited to) the C head (original), R head (heavy duty C head), M head, J head (and high speed, 5440 RPM version), 2J1 1/2 head (1.5 HP Vari-Speed), 2J2 (2HP Vari-speed), and Series II head (4HP Vari-speed).
Drilling a blast hole with a pneumatic drill (jackhammer). A pneumatic tool, air tool, air-powered tool or pneumatic-powered tool is a type of power tool, driven by compressed air supplied by an air compressor. Pneumatic tools can also be driven by compressed carbon dioxide (CO 2) stored in small cylinders allowing for portability. [1]
Peck drilling involves plunging the drill part way through the workpiece, no more than five times the diameter of the drill, and then retracting it to the surface. This is repeated until the hole is finished. A modified form of this process, called high speed peck drilling or chip breaking, only retracts the drill slightly. This process is ...
The largest machines can handle stock up to 3 in (76 mm) wide, 12.5 in (320 mm) long, and 3 ⁄ 32 in (2.4 mm) thick. For wires the limit is 1 ⁄ 8 in (3.175 mm). [ 3 ] Other limits are the travel on the slides, which maxes out at 3 ⁄ 4 in (19.05 mm), and the throw of the forming cams, which is between 7 ⁄ 8 and 2 in (22 and 51 mm).