Ads
related to: three jaw chuck for lathe
Search results
Results from the WOW.Com Content Network
A self-centering chuck, also known as a scroll chuck, [2] uses jaws, interconnected via a scroll gear (scroll plate), to hold onto a tool or workpiece. Because they most often have three jaws, the term three-jaw chuck without other qualification is understood by machinists to mean a self-centering three-jaw chuck.
The triangle shank is almost always made by machining three flats on round bar stock. It is intended as a minor modification of a straight shank, still allowing it to be held in a 3-jaw drill chuck, but allowing higher torque transmission and limited slipping. Can be held in a drill chuck; High torque transmission; Moderately accurate centering
The three-jaw chuck is used to hold round or hex workpieces because the work is automatically centered. On these chucks the runout faces limitations; on late-model CNCs, it can be quite low if all conditions are excellent, but traditionally it is usually at least .001-.003 in (0.025-0.075 mm).
Increasingly common is the camlock arrangement, in which shaped studs and cams replace threaded studs for rapid exchanging of the faceplate with other accessories, such as three or four jaw chucks. The faceplate was the ancestor of lathe chucks, an arrangement of three or more adjustable 'dogs' bolted to the faceplate providing a primitive ...
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
Brunel used detachable tool bits held in tool holders very similar to those use now on general purpose lathes. Expanding collet chucks were used to locate the sheaves by gripping the internal bore, during certain operations. Two-jaw gripping chucks were used on some machines. These were precursors of the three-jaw chucks used on lathes today.
Ads
related to: three jaw chuck for lathe