Search results
Results from the WOW.Com Content Network
If the aspect ratio is too large, the turbo will fail to create boost at low speeds; if the aspect ratio is too small, the turbo will choke the engine at high speeds, leading to high exhaust manifold pressures, high pumping losses, and ultimately lower power output. By altering the geometry of the turbine housing as the engine accelerates, the ...
A turbocharger does not place a direct mechanical load on the engine, although turbochargers place exhaust back pressure on engines, increasing pumping losses. [52] Supercharged engines are common in applications where throttle response is a key concern, and supercharged engines are less likely to heat soak the intake air.
The anti-lag system (ALS) is a method of reducing turbo lag or effective compression used on turbocharged engines to minimize turbo lag on racing or performance cars. It works by retarding the ignition timing and adding extra fuel (and sometimes air) to balance an inherent loss in combustion efficiency with increased pressure at the charging side of the turbo.
Diesel engine runaway is an occurrence in diesel engines, in which the engine draws excessive fuel from an unintended source and overspeeds at higher RPMs, producing up to ten times the engine's rated output resulting in a catastrophic mechanical failure due to a lack of lubrication. [1]
Diesel engines are typically well suited to turbocharging due to two factors: A "lean" air–fuel ratio, caused when the turbocharger supplies excess air into the engine, is not a problem for diesel engines, because the torque control is dependent on the mass of fuel that is injected into the combustion chamber (i.e. air-fuel ratio), rather than the quantity of the air-fuel mixture.
“It's going to separate winners from losers, and it's going to turbocharge the winners faster than you and I have been expecting based on the past 25 years of technology.” ...
A turbocharger for a car engine A supercharger (on top of a dark-grey inlet manifold) for a car engine. In an internal combustion engine, forced induction is where turbocharging or supercharging is used to increase the density of the intake air. Engines without forced induction are classified as naturally aspirated. [1]
It’s not only duration or intensity that matters on rides—but a combo of the two a.k.a. training load. Here’s how to track it and the benefits of doing so.