Search results
Results from the WOW.Com Content Network
Few systems transfer files and data by simply copying the contents of the file into the 'Data' field of HDLC or PPP frames — another protocol layer is used to format the data inside the 'Data' field of the HDLC or PPP frame. The most commonly used such protocol is Internet Protocol (IP), defined by RFC 791. This imposes its own overheads.
Speedtest.net, also known as Speedtest by Ookla, is a web service that provides free analysis of Internet access performance metrics, such as connection data rate and latency. It is the flagship product of Ookla, a web testing and network diagnostics company founded in 2006, and based in Seattle, Washington, United States. [5] [6]
In the latter case, inline appliances are preferred. These would generally 'sit' between the LAN and the LAN's exit point, generally the WAN or Internet router, and all packets leaving and entering the network would go through them. In most cases the appliance would operate as a bridge on the network so that it is undetectable by users.
Per the end-to-end principle, the Internet Protocol leaves responsibility for packet recovery through the retransmission of dropped packets to the endpoints - the computers sending and receiving the data. They are in the best position to decide whether retransmission is necessary because the application sending the data should know whether a ...
If a bottleneck communication link offering data rate R is shared by "N" active users (with at least one data packet in queue), every user typically achieves a throughput of approximately R/N, if fair queuing best-effort communication is assumed. Packet loss due to network congestion. Packets may be dropped in switches and routers when the ...
It specifies the latency for a bit of data to travel across the network from one communication endpoint to another. [1] [2]: 5 It is typically measured in multiples or fractions of a second. Delay may differ slightly, depending on the location of the specific pair of communicating endpoints.
Throughput is controlled by available bandwidth, as well as the available signal-to-noise ratio and hardware limitations. Throughput for the purpose of this article will be understood to be measured from the arrival of the first bit of data at the receiver, to decouple the concept of throughput from the concept of latency.
In telecommunication networks, the transmission time is the amount of time from the beginning until the end of a message transmission. In the case of a digital message, it is the time from the first bit until the last bit of a message has left the transmitting node.