enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Copper tube used for propane, liquefied petroleum gas, or natural gas may use flared brass fittings of single 45°-flare type, according to NFPA 54/ANSI. Z223.1 National Fuel Gas Code. Many plumbing codes, towns, and water companies require copper tube used for water service to be type-L or type-K.

3. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

5. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The history of copper pipe is similar. In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings.

6. Oxy-fuel welding and cutting - Wikipedia

   en.wikipedia.org/wiki/Oxy-fuel_welding_and_cutting

   The following is a comparison of operating costs in cutting 1 ⁄ 2 in (13 mm) plate. Costing is based on an average cost for oxygen and different fuels in May 2012. [obsolete source] The opex with Gasoline was 25% that of propane and 10% that of acetylene. Numbers will vary depending on source of oxygen or fuel and on the type of cutting and ...

7. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   The sleeve is used to evenly distribute the compressive forces of the flare nut to the flared end of the tube. Materials commonly used to fabricate JIC fittings include forged carbon steel , forged stainless steel , forged brass , machined brass, Monel and nickel-copper alloys.