Search results
Results from the WOW.Com Content Network
A Diameter Application is not a software application but is a protocol based on the Diameter base protocol defined in RFC 6733 (obsoletes RFC 3588) and RFC 7075. Each application is defined by an application identifier and can add new command codes and/or new mandatory AVPs ( Attribute-Value Pair ).
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
Most code pages used by MS-DOS such as CP437 did not contain this character; in Scandinavian codepages, Ø replaces the yen sign (¥) at 165, and ø replaces the ¢ sign at 162. The 8-bit ISO-8859-1 and similar sets used 0xD0 and 0xF0 ; these locations were then inherited by CP1252 on Windows, and by Unicode .
The final number in the code (e.g.,"14") is the mating wheel diameter measured in inches. The overall circumference of the tire will increase by increasing any of the tire's specifications. For example, increasing the width of the tire will also increase its circumference, because the sidewall height is a proportional dimension.
Diameter Credit-Control Application is a networking protocol for Diameter application used to implement real-time credit ... Command Code for CCR/CCA is 272, as ...
Standardized code or diameter code Diameter modifier Height code Height adjustment modifier Modifier(s) Parallel strings Remarks R20: R: 20: A single zinc-carbon cell, "size 20" which is equivalent to D, or ANSI "13" size 4R25X: 4: R: 25: X: A zinc-carbon lantern battery, consisting of 4 round "size 25" cells in series. Terminated with spring ...
The overall diameter of the tire is then the rim diameter plus twice the tire's section height. The ISO 5775-1 standard also defines procedures for measuring tires and for calculating from the marking the maximum dimensions of a tire, which are needed by designers to determine clearance distances to other bicycle components.
The diameter or metric diameter of a subset of a metric space is the least upper bound of the set of all distances between ... The symbol has a code point in Unicode ...