Search results
Results from the WOW.Com Content Network
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
A screw thread is an inclined plane wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread. More screw threads are produced each year than any other machine element. [1] Threads are generally produced according to one of the many standards of thread systems.
The #6-32 UNC is a UTS screw specifying a major thread diameter of #6 which is defined as 0.1380 inches (3.51 mm); and 32 tpi (threads per inch) which equates to a thread pitch of 0.031250 inches (0.7938 mm). The optional UNC specification indicates the standard coarse thread is used which is defined for #6 screws as 32 tpi rendering 'UNC ...
Standard threads are commonly identified by short letter codes (M, UNC, etc.) which also form the prefix of the standardized designations of individual threads. Additional product standards identify preferred thread sizes for screws and nuts, as well as corresponding bolt head and nut sizes, to facilitate compatibility between spanners ...
U.S. Standard threads became the National series (e.g., NC, NF, NEF), which became the Unified National series (e.g., UNC, UNF, UNEF); see Unified Thread Standard. As for U.S. Steel, it was once the largest steel company on earth, often an approved supplier, and not infrequently a sole source; hence its mention on drawings. UTS
A common use for cage nuts is to mount equipment in square-holed 19-inch racks (the most common type), with 0.375 inches (9.5 mm) square-hole size. There are four common sizes: UNF 10–32 and, to a lesser extent, UNC 12–24 are generally used in the United States; elsewhere, M5 (5 mm outside diameter and 0.8 mm pitch) for light and medium equipment and M6 for heavier equipment, such as servers.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
United States Standard thread (USS thread), also known as Sellers Standard thread, [1] Franklin Institute thread [1] and American Standard thread, [2] is a standard for inch based threaded fasteners and washers. [3] The USS standard is no longer supported. It, together with the SAE fastener standard, was incorporated into the Unified Thread ...