Search results
Results from the WOW.Com Content Network
ISO 10628 Diagrams for the chemical and petrochemical industry specifies the classification, content, and representation of flow diagrams. It does not apply to electrical engineering diagrams. ISO 10628 consists of the following parts: Part 1: Specification of Diagrams (ISO 10628-1:2014) [1] Part 2: Graphical Symbols (ISO 10628-2:2012)
Date: 22 November 2016: Source: Heinrich, Martin (2016-11-22) Genetic Optimization of Turbomachinery Components using the Volute of a Transonic Centrifugal Compressor as a Case Study (Dr.-Ing), Technische Universität Bergakademie Freiberg, archived from the original on 2021-12-07, page 5, Figure 2.1
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...
A compressor map is a chart which shows the performance of a turbomachinery compressor. This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor. A map is created from compressor rig test results or predicted by a special computer program.
An indicator diagram is a chart used to measure the thermal, or cylinder, performance of reciprocating steam and internal combustion engines and compressors. [1] An indicator chart records the pressure in the cylinder versus the volume swept by the piston, throughout the two or four strokes of the piston which constitute the engine, or ...
[1] The other type of hydraulic compressor uses the potential and kinetic energy of a stream of water to entrain air and carry it to a separating chamber at a higher pressure where the air accumulates above the water, and the water is allowed to drain. The system has few, if any, moving parts, and is also inefficient, so it is used where the ...
The PW 300 series has been developed in partnership with MTU who are responsible for the low pressure turbine. The first variant, the PW305A, has the following configuration and was designed with a core flexible enough for engines with take-off thrusts from 20 kN to 31 kN (4,500 to 7,000 lb): a single-stage fan driven by a three-stage low pressure turbine, supercharging a four-stage axial ...
Thermodynamic diagrams are diagrams used to represent the thermodynamic states of a material (typically fluid) and the consequences of manipulating this material. For instance, a temperature– entropy diagram ( T–s diagram ) may be used to demonstrate the behavior of a fluid as it is changed by a compressor.