enow.com Web Search

  1. Ads

    related to: abrasive stones polishing

Search results

  1. Results from the WOW.Com Content Network
  2. Tumble finishing - Wikipedia

    en.wikipedia.org/wiki/Tumble_finishing

    A well-chosen speed for stone polishing causes the rocks within the barrel to slide past each other, with the abrasive grit between them. The result of this depends on the coarseness of the abrasive, and the duration of the tumble. Typically, a full tumble polish from rough rock to polish takes 3–5 weeks, and is done in a minimum of 3 steps.

  3. Rotten stone - Wikipedia

    en.wikipedia.org/wiki/Rotten_stone

    For larger polishing jobs, rotten stone mixed with a binder is applied to polishing wheels. It has also been used to polish brass, such as that found on military uniforms, as well as steel and other metals. Plates used in daguerreotypes were polished using rotten stone, the finest abrasive available at the time.

  4. Polishing (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Polishing_(metalworking)

    The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.

  5. Abrasive - Wikipedia

    en.wikipedia.org/wiki/Abrasive

    A bonded abrasive grind wheel may be used to commercially sharpen a knife (producing a hollow grind), but an individual may then sharpen the same knife with a natural sharpening stone or an even flexible coated abrasive (like a sandpaper) stuck to a soft, non-slip surface to make achieving a convex grind easier. Similarly, a brass mirror may be ...

  6. Superfinishing - Wikipedia

    en.wikipedia.org/wiki/Superfinishing

    Superfinishing, also known as microfinishing [1] and short-stroke honing, is a metalworking process that improves surface finish and workpiece geometry. This is achieved by removing just the thin amorphous surface layer of fragmented or smeared metal left by the last process with an abrasive stone or tape; this layer is usually about 1 μm in magnitude.

  7. Polishing - Wikipedia

    en.wikipedia.org/wiki/Polishing

    Polishing is the process of creating a smooth and shiny ... black or transparent stones), polishing is also able to reduce ... abrasive paste polishing, polishing for ...

  1. Ads

    related to: abrasive stones polishing