Search results
Results from the WOW.Com Content Network
However, a transformer may include a tap changer on each winding if there are advantages to do so. For example, in power distribution networks, a large step-down transformer may have an off-load tap changer on the primary winding and an on load automatic tap changer on the secondary winding or windings. The high voltage tap is set to match long ...
a load tap changer (LTC) at the substation transformer, which changes the turns ratio in response to load current and thereby adjusts the voltage supplied at the sending end of the feeder; voltage regulators , which are essentially transformers with tap changers to adjust the voltage along the feeder, so as to compensate for the voltage drop ...
Both linear spacing and power-of-two-style Vernier spacing can be employed in establishing the tap positions, e.g., a four-tap transformer can provide taps at 0.25, 0.5, 0.75, 1.0 (linear) or 0.0625, 0.125, 0.25, and 0.5 (Vernier). (The limitations of the Vernier—in this case, that the maximum obtainable amplitude is 0.9375—are less ...
In electrical engineering, an autotransformer is an electrical transformer with only one winding. The "auto" (Greek for "self") prefix refers to the single coil acting alone. In an autotransformer, portions of the same winding act as both the primary winding and secondary winding sides of the transformer. In contrast, an ordinary transformer ...
In switch-mode power supplies, center-tapped transformers are often used, sometimes with single diodes or a dual diode half-bridge [2] to optimize their dynamic electromagnetic behavior at the expense of the extra windings. [3] Phantom power can be supplied to a condenser microphone using center tap transformers. One method, called "direct ...
C mathematical operations are a group of functions in the standard library of the C programming language implementing basic mathematical functions. [1] [2] All functions use floating-point numbers in one manner or another. Different C standards provide different, albeit backwards-compatible, sets of functions.
C11 (previously C1X, formally ISO/IEC 9899:2011), [1] is a past standard for the C programming language. It replaced C99 (standard ISO/IEC 9899:1999) and has been superseded by C17 (standard ISO/IEC 9899:2018).
A tap-changer is an electrically operated (usually) mechanical device used for changing the tapping usually on the primary of a high voltage transmission transformer in order to alter the voltage at the transformer secondary for the purpose of regulation of the voltage at the load (consumer) end of the line. This sentence is barely comprehensible.