Search results
Results from the WOW.Com Content Network
An extension to the rule of three was the double rule of three, which involved finding an unknown value where five rather than three other values are known. An example of such a problem might be If 6 builders can build 8 houses in 100 days, how many days would it take 10 builders to build 20 houses at the same rate? , and this can be set up as
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
A quantity equation, also sometimes called a complete equation, is an equation that remains valid independently of the unit of measurement used when expressing the physical quantities. [28] In contrast, in a numerical-value equation, just the numerical values of the quantities occur, without units. Therefore, it is only valid when each ...
To test whether the third equation is linearly dependent on the first two, postulate two parameters a and b such that a times the first equation plus b times the second equation equals the third equation. Since this always holds for the right sides, all of which are 0, we merely need to require it to hold for the left sides as well:
As corollaries (multiplying or dividing the above formula in terms of and ) we obtain two dual statements to Mollweide's formulas. The first expresses the area in terms of two sides and the included angle, and the other is the law of sines: = ,
Similarly, RHS is the right-hand side. The two sides have the same value, expressed differently, since equality is symmetric. [1] More generally, these terms may apply to an inequation or inequality; the right-hand side is everything on the right side of a test operator in an expression, with LHS defined similarly.
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t
Fold change is a measure describing how much a quantity changes between an original and a subsequent measurement. It is defined as the ratio between the two quantities; for quantities A and B the fold change of B with respect to A is B/A. In other words, a change from 30 to 60 is defined as a fold-change of 2.