Search results
Results from the WOW.Com Content Network
In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...
Note the connection of the security system to the phone line requires a wiring configuration that allows the security system to disconnect all phones in the home when it needs to connect to the monitoring center. This is critical, if the wiring is not correct the system may not communicate back to base when an intrusion is detected.
The voltage and frequency of electric power differs between regions. In much of the world, a voltage (nominally) of 230 volts and frequency of 50 Hz is used. In North America, the most common combination is 120 V and a frequency of 60 Hz. Other combinations exist, for example, 230 V at 60 Hz.
Voltage/Frequency map: Different shades of the colors for slightly differing voltages (approx. 220, 230, 240 volts or 110, 120 or 127 volts) I hope any further removal of these maps in favor of the old ones includes equally good reasons. (By the way, in case you find mistakes in one of the maps you can always use my discussion page.)
However, electrical wiring is a very inefficient antenna, and this results in a transmitted effective radiated power of less than one watt, and the distance over which signals can be picked up is usually less than 60 meters (200 feet) from the wires. Transmission sound quality can be good, although it sometimes includes the low-frequency mains ...
for AC having a supply frequency of 50, 60 or 400Hz, though the use of other frequencies for special purposes is not excluded. This includes low-voltage installations, as found in most domestic and commercial properties, and extra-low-voltage systems, but excludes high voltage , as found in generation, transmission and distribution networks.
Moreover, the ITU-T extended the technology with multiple input, multiple output (MIMO) technology to increase data rates and signaling distance. [6] This new feature was approved in March 2012 under G.9963 Recommendation. The development and promotion of G.hn have been significantly supported by the HomeGrid Forum and several other ...
The significance of each category or class is the limit values of which the Pass/Fail and frequency ranges are measured: Cat 3 and Class C (no longer used) test and define communication with 16 MHz bandwidth, Cat 5e and Class D with 100 MHz bandwidth, Cat 6 and Class E up to 250 MHz, Cat6A and Class EA up to 500 MHz, Cat7 and Class F up to 600 ...