Search results
Results from the WOW.Com Content Network
Diagram showing a transform fault with two plates moving in opposite directions Transform fault (the red lines) A transform fault or transform boundary, is a fault along a plate boundary where the motion is predominantly horizontal. [1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or ...
Obduction zones occurs when the continental plate is pushed under the oceanic plate, but this is unusual as the relative densities of the tectonic plates favours subduction of the oceanic plate. This causes the oceanic plate to buckle and usually results in a new mid-ocean ridge forming and turning the obduction into subduction. [citation needed]
The GTJ does not form a typical ridge–ridge–ridge triple junction. In plate collision, this would be the "perfect" scenario. Divergent and convergent plate boundaries can form ridges, trenches, and/or faults. The shortened R, T, and F are used to symbolize when put together what kind of structures are formed on the plate boundaries. In ...
Strike-slip tectonics or wrench tectonics is a type of tectonics that is dominated by lateral (horizontal) movements within the Earth's crust (and lithosphere).Where a zone of strike-slip tectonics forms the boundary between two tectonic plates, this is known as a transform or conservative plate boundary.
Isthmus – Narrow strip of land connecting two larger land areas; Lagoon – Shallow body of water separated from a larger one by a narrow landform; Machair – Fertile low-lying grassy plain; Marine terrace – Emergent coastal landform; Mid-ocean ridge – Basaltic underwater mountain system formed by plate tectonic spreading
Fold mountains form in areas of thrust tectonics, such as where two tectonic plates move towards each other at convergent plate boundary.When plates and the continents riding on them collide or undergo subduction (that is – ride one over another), the accumulated layers of rock may crumple and fold like a tablecloth that is pushed across a table, particularly if there is a mechanically weak ...
Extensional tectonics is associated with the stretching and thinning of the crust or the lithosphere.This type of tectonics is found at divergent plate boundaries, in continental rifts, during and after a period of continental collision caused by the lateral spreading of the thickened crust formed, at releasing bends in strike-slip faults, in back-arc basins, and on the continental end of ...
Fault blocks are very large blocks of rock, sometimes hundreds of kilometres in extent, created by tectonic and localized stresses in Earth's crust. Large areas of bedrock are broken up into blocks by faults. Blocks are characterized by relatively uniform lithology. The largest of these fault blocks are called crustal blocks.