enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   Table saw. A table saw (also known as a sawbench or bench saw in England) is a woodworking tool, consisting of a circular saw blade, mounted on an arbor, that is driven by an electric motor (directly, by belt, by cable, or by gears). The drive mechanism is mounted below a table that provides support for the material, usually wood, being cut ...

3. Wood shingle - Wikipedia

   en.wikipedia.org/wiki/Wood_shingle

   The shingle edges are then cut with another circular saw called a "trim saw" to remove irregular edges. The result is a tapered shingle sawn on all six sides. The thickness of the butt, or thicker end of the tapered cut, is usually 3 ⁄ 8 inch (9.5 mm) thick but is also commonly made to be 5 ⁄ 8 inch (16 mm), and can be made to any custom ...

4. Straight razor - Wikipedia

   en.wikipedia.org/wiki/Straight_razor

   Sizing of a standard straight razor is usually close to 3 inches of blade length, but this does vary. Blades are described by the depth from spine to edge, measured in eights of an inch. 3/8 is a very narrow razor mostly used for detail work, with 5/8 and 6/8 being the most commonly seen sizes.

5. Water jet cutter - Wikipedia

   en.wikipedia.org/wiki/Water_jet_cutter

   A water jet cutter, also known as a water jet or waterjet, is an industrial tool capable of cutting a wide variety of materials using an extremely high-pressure jet of water, or a mixture of water and an abrasive substance. The term abrasive jet refers specifically to the use of a mixture of water and an abrasive to cut hard materials such as ...

6. Physics of whistles - Wikipedia

   en.wikipedia.org/wiki/Physics_of_whistles

   An example of this device is shown in the figure on the right; it had a 0.125-inch-diameter (3.2 mm) hole, was 1.9 in (48 mm) long, and 0.8 in (20 mm) in diameter. The quarter-wave resonance was calculated to be 1780 Hz, while the measured fundamental was 1625 Hz with detectable second and third harmonics.

7. Plough - Wikipedia

   en.wikipedia.org/wiki/Plough

   Water buffalo used for ploughing in Laos. A plough or (US) plow (both pronounced / plaʊ /) is a farm tool for loosening or turning the soil before sowing seed or planting. [1] Ploughs were traditionally drawn by oxen and horses but modern ploughs are drawn by tractors. A plough may have a wooden, iron or steel frame with a blade attached to ...